Benbox Laser Machines/CO2 Lasers/3D Printers

Building Your Own Laser => Custom Size Frames => Topic started by: jmarsden92 on January 08, 2020, 07:16:43 PM

Title: Question...
Post by: jmarsden92 on January 08, 2020, 07:16:43 PM
I have a 65x50 cm laser engraver with blue laser...  the board is a DCCduino...  It has a 2 wire connector on the board that leads to the laser power module...  I just purchased a eleksmaker mana se.  I wanted to go to that board, but the laser is a 3 wire on the board...  suggestions?
Title: Re: Question...
Post by: ggallant571 on January 08, 2020, 08:07:24 PM
I believe the 2-pin header labeled MOTOR on the SE is the PWM switched power for connecting to 2-wire diode modules.
Title: Re: Question...
Post by: Zax on January 09, 2020, 04:18:08 AM
Correct.