Benbox Laser Machines/CO2 Lasers/3D Printers

General Category => Projects => Topic started by: MassimilianoMarradi on March 09, 2016, 07:36:58 AM

Title: Test
Post by: MassimilianoMarradi on March 09, 2016, 07:36:58 AM
Ciao.

This is something I did, I consider these just a test.
The Robots are on soft wood, I don't know what.
The fishes and the treehouse are on plywood, Gundam too.
The owl on cherry tree.
Title: Re: Test
Post by: MassimilianoMarradi on March 09, 2016, 07:39:09 AM
And...
Title: Re: Test
Post by: MassimilianoMarradi on March 09, 2016, 07:41:26 AM
And...
Title: Re: Test
Post by: Zax on March 09, 2016, 09:10:53 AM
Were these done with Benbox?
Title: Re: Test
Post by: Zax on March 09, 2016, 09:16:53 AM
All done with T2Laser software.

The wood box and squares are pine, the Cowboys logo is on a wood flooring sample and the million dollar bill is a thin piece of ply (it's actual size and has amazing detail).

- Zax.
Title: Re: Test
Post by: Administrator on March 09, 2016, 11:07:58 AM
@Mass it would be interesting to see your same images done using @Zax's T2 software...
Title: Re: Test
Post by: MassimilianoMarradi on March 09, 2016, 01:58:00 PM
Yes, I'll be happy to test.
Title: Re: Test
Post by: caperry88 on March 16, 2016, 02:09:38 PM
@Mass those are nice, using the MAC?
Title: Re: Test
Post by: MassimilianoMarradi on March 21, 2016, 01:48:34 AM
Ciao.

Unfortunately, the software that you can use on Mac is not so good, as i've told you in the other post.
These are done with a Windows 7 VM on my Mac.
Title: Re: Test
Post by: pianotech70 on March 25, 2016, 07:27:18 PM
My first laser project of any success, done on olive wood with a Benbox DIY 300mw laser
Title: Re: Test
Post by: caperry88 on March 26, 2016, 09:02:34 AM
very nice
Title: Re: Test
Post by: MassimilianoMarradi on March 26, 2016, 09:10:57 AM
My first laser project of any success.

Ciao.

Nice, but the space between the "pixel" and the line where there should be a point... I think you used a too fast setting. With high speed the laser moves fast, and the "engine break" is not enough to stop and made a single point, so it became a line.

If you change slightly the settings, slowing down, I'm sure you'll get a better one.

Let us know.
Title: Re: Test
Post by: pianotech70 on March 26, 2016, 09:42:58 AM
Will give that a shot. Still learning this software, and I am a slow learner!!1