Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - distefanom

Pages: [1]
1
T2 Software Updates / Installing T2Laser on my XP machine
« on: October 02, 2016, 10:59:41 AM »
Hi,
I've tried this evening to install the T2Laser software instead the original Benbox machine; but surprising to me, I got:

"Prerequisite check for system component Microsoft .NET Framework 4.5 (x86 and x64) failed with the following error message:
"Installation of the Microsoft .NET Framework 4.5 is not supported on this operating system. Contact your application vendor."

Get stuck by this, I tried to search if there is a suitable version of Microsoft .NET Framework 4.5; but microsoft, unfortunately, discontinued XP  :P

Do you know if there is any way to overcome this problem without  nuking my pc?
Many thanks to any help
ciao
Mario
p.s. sorry if it's the wrong thread.
Admins: feel free to move it anyplace. thenks

2
Benbox / engraving jpg b/w images with benbox
« on: September 28, 2016, 02:23:35 PM »
Hi to all!
I have a 0,5W xy table laser, and want to engrave precisely, a little b/w drawing.
My only constraint is that I want to resize the image just before start engraving.
To do so, in benbox, I loaded the image (you can find it attached).
Just resized it, really a bit, to the desired heght/width lenght and pushed the green ">".
All I get is just a etched rectangular contour of the image. With nothing inside.
After several tries, I just sent the original image, again,  to the xy table, but without resizing it.
This way, I get the image correctly etched, but with undesired
dimensions.
To make it even more strange, Yesterday evening I didn't have this problem.
This happened just after I "edited" the jpg image, making it in reverse, doble clicking and clicking the upper right little square
which appears when you try to "edit" the image a little. I did it in reverse (B/W) and reverse again.
Then after, benbox didn't worked well as before.
I also tried to reinstal benbox, but nothing happened.
Do anybody has this very same experience?
please let me know.
ciao
M

3
Manuals and Documentation / Eleks Maker L2 electrical schematic - circuit
« on: September 11, 2016, 09:08:47 AM »
Hi to all!
I tried to reverse-engineering the Eleks Maker L2 board and attached is the pdf file.
Hope someone will find it useful. You can use it freely, but you cannot modify credits.
thanks

4
General Discussion / Jumper for (GRBL?) VERSION
« on: September 09, 2016, 01:30:59 PM »
Hi to all! :D
I've just programmed My eleks Maker L2 board and after removing the arduino nano, I found this jumper.
How could I know if it is properly set?
Is it written somewhere in the benbox software (ver 3.7.99), where this jumper has to be set?
I imagined it refers to the GRBL version, but could not find written it anywhere.
Pls have a look at the photo.
 :(

5
Buy and Sell / Engraver structure
« on: September 08, 2016, 08:09:35 AM »
Hi to all.
I'm searching for an engraver mechanical structure without controller & laser compatible with Eleks T2.
If someone has one, and want to sell it, please let me know.
Pls consider that I live in Italy, for the postage expenses.
ciao
Mario

Pages: [1]