Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - 6Firewall6

Pages: [1]
1
Projects / Pistol box
« on: December 09, 2019, 05:25:08 PM »
I wanted to make a wood storage box for a pistol i got my girlfriend for Christmas. I purchased the box at Michaels and engraved her favorite sea creature in on the lid. I then used the laser to mark and start a cut on the foam i used on the inside. I was not able to cut all the way bit it gave me a good starting point. After I put Felt on the underside of the lid I engraved the Ruger logo. I finished it off by covering the pink foam with blue velvet.

2
T2 Software Updates / odd y axis issue
« on: December 02, 2019, 06:59:56 PM »
Odd issue after an update to 1.5y in T2. When I try to engrave anything the Y axis shows the full number of steps but the carriage only goes for half the distance. the X axis has no issues has anyone else seen this?

3
Engraving / Batch engraving
« on: August 11, 2019, 09:26:50 AM »
I have a large amount (100+) of wood token that I need to engrave for a convention and would like to do them in groups to speed up process as I will need to do both sides. Any suggestions on how to line them all up and burn in groups?

4
T2 Engraving / * next to axis
« on: February 03, 2019, 12:04:22 PM »
any idea what the * next to axis mean?

5
T2 Engraving / T2Laser to raspberry pi
« on: January 11, 2019, 08:44:05 PM »
Has anyone ever set up a way to use a raspberry pi as a server to receive commands from T2 laser via wireless?

6
Projects / GoT scotch Glass
« on: January 09, 2019, 06:21:20 PM »
In preparation for my re-watch of Game of Thrones before the final season I decided that my Scotch glass needed some work.
1000/255/.1

7
General Discussion / Longer legs
« on: December 30, 2018, 12:36:13 PM »
I am thinking about building longer legs for my unit to allow it to use the rotary I had printed  and then go back to normal use with out having to move the unit each time. I have it mounted in side of a box i built to hold everything and bolted down whit l brackets right now. Is that any issue whit the framing being further away from the project for normal engraving use? Here is my current set up.

8
Engraving / Engraving a Mirror
« on: December 08, 2018, 05:11:45 PM »
I am planing on doing backlit engraved mirrors for my nieces for Christmas and since my new 2.5w module showed up I started testing to check the settings I would need based on what I have read on here. I ran the image at Speed:1500 Power:255 in T2 laser. I only did one pass and when  pulled the mirror out of my encloser i could see were it had engraved the back of the mirror but not in both layers. Do i need to go slower or do multiable passes?


9
LaserGrbl / Swaping Y axis
« on: November 25, 2018, 08:59:27 PM »
I have tried to use this program with my Engraver and the Y access is set the wrong way for me. Is there any way in the program to swap the y axis? I know I can in T2  and in Elekcam . I have not tried any other software yet.

Pages: [1]