Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Wheelz

Pages: [1]
1
T2 Engraving / Connector type?
« on: November 14, 2019, 09:49:29 PM »
I've just taken delivery of a stepper motor for my rotary axis and it has arrived with bare wires.
Can anyone please tell me what the name of the connector is (as shown) that I need to connect it to the board?

Thanks.

2
T2 Engraving / Home Position Keeps Moving
« on: April 13, 2019, 10:46:12 PM »
If I'm burning multiple parts, or if I interrupt a run, my home position is altered by X:11.4 Y:5.3 every time.
I have to move it back and Set Home Position again. If I forget to, obviously, I get double image cut.
Why won't it hold my home position?

3
T2 Engraving / Home Switches
« on: April 13, 2019, 06:41:44 PM »
I have a DVP6550 5.5w from Ebay and I've seen an old thread where home switches are required to use Machine Home.
Is there thread describing the installation and where to purchase these?

Cheers,
Pete

Pages: [1]