Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - GTIBert

Pages: [1]
1
Cutting / Cardboard 2mm
« on: September 24, 2020, 04:05:56 AM »
It is normal that I have to cut 15 x 2mm gray cardboard before it is cut through.
It seems that the power drops during cutting.
Who has tips or tricks in this.

I like to hear it.


Mvg Bert.

2
LaserGrbl / Cutting
« on: September 24, 2020, 04:04:32 AM »
It is normal that I have to cut 15 x 2mm gray cardboard before it is cut through.
It seems that the power drops during cutting.
Who has tips or tricks in this.

I like to hear it.


Mvg Bert.

3
BenCutLaser / Snij uren Laser (CLOSED)
« on: September 23, 2020, 03:21:02 AM »
Hallo.

Ik ben hier nieuw op het forum en mijn naam is Bert.
Ik probeer met een 2.5W laser te snijden.
Nu is mijn vraag. wat zijn de brand uren van een Laser snijder?
Hoe kan ik zien dat de snij sterkte achteruit gaat?

Ik hoor het graag


mvg bert

Pages: [1]