Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Ton vM

Pages: [1]
1
BenCutLaser / eleksmana v5.2 (Resolved)
« on: May 16, 2021, 05:50:22 AM »
Hello,

I hope someone can help me with the following.
 
Iam using the laser cut program for some time now and it works just fine om my Banggood set with a 3000mW laser.
 
But this week the board burned on the laser circuit, but the laser was still worked on an separate powerset.
 
Along with the set I also ordered a Eleksmaker v5,2 board which works after flashing with the 1.1e.
 
But the strange thing is that the Laser connector is giving a constant feed of 15V which also has blown (I think) my laser because its not workig anymore.
 
The program is working with the board and the stepper motors, but I donít understand why the 15V is continuosly on the laser connector.

On the board the laser is with 3 pins + / gnd / S  which I connected to the Laser board and connected the S on the ttl pin but it stays on the 15V output to the laser.
 
I hope anyone can help and thanks in advance.
 
Thanks in advance , Ton


Pages: [1]