Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Redajawad

Pages: [1]
1
T2 Engraving / Re: I cant print grayscale
« on: January 21, 2020, 01:27:25 AM »
Hi Zax
In Benbox parameters it shows 11
I install your T2laser  grbl 1.1e to my router and it works
I try to print grayscale but it didn't print that
Only black
I attached image for output
Another question
If my board not support that
Can I change board and plz advise me which one is good and supported for future
Thank you

2
T2 Engraving / Re: I cant print grayscale
« on: January 20, 2020, 09:04:49 AM »
Hi Zax
thank u
Sorry but how can I know if it is D11 or D12
Also can i update your firmware without problems (I mean is it compitable with my router)
And if I try T2laser can I return to Benbox
Thanks

3
T2 Engraving / Re: I cant print grayscale
« on: January 20, 2020, 07:42:09 AM »
Also this

4
T2 Engraving / Re: I cant print grayscale
« on: January 20, 2020, 07:41:01 AM »
Hi
Thank you
I am sorry
i am new to this world but have some experience in electronics so can you explain what is Arduino Nano and how I add it and did my controlor board didn't Support grayscale so I need to change it
I search and find like this (mana se laser board)
And what the modification I need
I attavh photo for my board

5
T2 Engraving / Re: I cant print grayscale
« on: January 20, 2020, 04:42:35 AM »
I download the software and connect it but nothing happen
As I read I must upgrade hex file
So iam afraid to do this before your answer

6
T2 Engraving / I cant print grayscale
« on: January 20, 2020, 04:40:26 AM »
Hi
I bought this router from ali Express
#Aliexpress Your US $2.00 in coupons are here!
https://a.aliexpress.com/_sOno8v

Its benbox 3.799
I try to print images and grayscale
But it make only black result
So can I use t2laser software
And did my router support it
Because in documents say don't change firmware
So what can I do
If yes plz give me links and the way to upgrade it
Thanks

7
Benbox / Re: YES IT WORKS!! LOW LASER ON BENBOX!!
« on: January 19, 2020, 03:58:48 PM »
hi I bought a new laser benbox 3.799 is it safe to upload this hex file to it

Pages: [1]