Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Grossarosa2

Pages: [1]
T2 Engraving / Re: Laser quit burning
« on: June 17, 2021, 02:09:23 PM »
Thanks Zax, you are always a big help. Appreciate the assist.  It is a 2 pin - I think I'm going to step up to a bigger laser.

T2 Engraving / Re: Laser quit burning
« on: June 14, 2021, 11:14:25 AM »
To add a little more detail,  the cable to the motherboard is a 2 pin plug that goes to a control box, them 4 wires to the laser head.  Which is the dilemma in getting a replacement.

T2 Engraving / Laser quit burning
« on: June 13, 2021, 08:34:05 AM »
Howdy Folks!

So my no-name Chinese laser quit burning in the middle of a job - still lights up just not enough juice to burn.  It is a 3W laser = so I am guessing it is toast.  Thinking of replacing with a 5W - but not sure if the cnc controls would work right.  Any thoughts on what to do???

FAQs For New Users / Re: Squiggly lines
« on: October 08, 2020, 12:12:34 PM »
Thanks all!

FAQs For New Users / Squiggly lines
« on: October 07, 2020, 12:08:01 PM »
Again you guys are a great help with this stuff, appreciate your help! Trying to make a hatch waste board, but my left to right burns on the line are wavy?  I am hoping it is somehow the roller belt and not a crappy engraver - but not sure if I should loosen tighten or look for other problems. Anyone have this problem before.  My laser is a Universal blue burner....

FAQs For New Users / Re: Straight to T2?
« on: September 05, 2020, 01:51:20 PM »
Much appreciated!  This is a great forum and you guys are super responsive - appreciate the help!  Will have more dumb questions as soon as I clear out a space in the shop!

FAQs For New Users / Straight to T2?
« on: September 04, 2020, 07:14:40 PM »
So I bought a universal 3000mW blue engraver and thought I did my research - but apparently not deep enough.  I am not sure I have the CNC skills to pick this up, so it might be for sale soon.  ;D

My question is can I assemble the machine and go straight with T2 software.  The info that came with the machine is highly confusing and T2 looks a lot easier to use.  I don't know if I have to install  universal's software first or not - I don't want to toast this thing right out of the box.

Appreciate any advice!!

Pages: [1]