Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Ton vM

Pages: [1]
BenCutLaser / Re: eleksmana v5.2
« on: May 17, 2021, 02:03:48 PM »
Thanks for your help and advice I will look into the Eleksmaker laser and the alternatives and will post an update if the system is running again.

BenCutLaser / Re: eleksmana v5.2
« on: May 16, 2021, 03:35:45 PM »
The question now is what would be a nice laser to use with the Eleksmana V5.2 board.

And for cutting balsa wood and 3mm ply.

BenCutLaser / Re: eleksmana v5.2
« on: May 16, 2021, 03:31:32 PM »
When making the pics I think that I have seen what the problem is.

When burning the laser route in the old board I think there was also an overload on the laser board itself.

Because it shows that the part on the pic is cracked and looks blownup

BenCutLaser / Re: eleksmana v5.2
« on: May 16, 2021, 12:31:20 PM »
Thanks for the reaction Zax

I have no problem that the reading is 15 V in stead of 12 V because its not under load.

But what I mean is that the 15V is constant on the pins directly to the laser.

I have pinned the V-meter on the plug where the laser is plugged in.

I can imagine that that should be giving a ready when the laser is needed during cutting and not all the time.

Hope the pickies makes it a little clear

BenCutLaser / eleksmana v5.2 (Resolved)
« on: May 16, 2021, 05:50:22 AM »

I hope someone can help me with the following.
Iam using the laser cut program for some time now and it works just fine om my Banggood set with a 3000mW laser.
But this week the board burned on the laser circuit, but the laser was still worked on an separate powerset.
Along with the set I also ordered a Eleksmaker v5,2 board which works after flashing with the 1.1e.
But the strange thing is that the Laser connector is giving a constant feed of 15V which also has blown (I think) my laser because its not workig anymore.
The program is working with the board and the stepper motors, but I donít understand why the 15V is continuosly on the laser connector.

On the board the laser is with 3 pins + / gnd / S  which I connected to the Laser board and connected the S on the ttl pin but it stays on the 15V output to the laser.
I hope anyone can help and thanks in advance.
Thanks in advance , Ton

Pages: [1]