1
T2 Engraving / Re: Colors in PDF not picked up by T2. (Solved)
« on: June 14, 2020, 04:21:42 PM »
OT post, but the cabinet and the model are both really cool!
Jerry
Jerry
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Free for personal use. Quoted below. See https://www.autodesk.com/campaigns/fusion-360-for-hobbyists
"Fusion 360 is available for free personal use for individuals who are doing home-based, non-commercial design, manufacturing, and fabrication projects.
Will report back once I try the other .hex.
How do you get Fusion 360 for free? When I looked into it, it was pretty expensive.
N/O would imply parallel wiring, one switch per axis. The port is set with an internal pull-up and held high until the switch trips. The switch closure shorts to GND.
I build my own. If you like soldering I will mail a blank. The pcb shops run specials where you can get 5 boards for 5USD. Sometimes with free shipping. Have been looking into getting the fabrication also done. I started with a L7 and it was random. Bought an L2 which died in 2 minutes.
I'm going out to cut down that proto board and see what happens.
If your laser has 2 wires then you need a controller with the on-board switching MOSFET.