Author Topic: At a Loss  (Read 1319 times)

mestguy182

  • Newbie
  • *
  • Posts: 1
    • View Profile
At a Loss
« on: February 28, 2021, 12:41:53 PM »
Hi All,

My Father-in-law recently purchased this engraver:https://universalengraver.com/products/3000mw-blue-cnc-laser-engraving-machine

He couldn't figure it out so he asked me to take it and fiddle around with it. The USB connector broke off the Mini Nano board the first time I tried using it so I purchased another board.

So, I have Benbox installed, I have the driver from the manufacturer installed, I get a com port, etc.

However none of the controls work in Benbox so I don't think my computer is properly communicating with the engraver. The light on the Mini Nano board was blinking Red for awhile so I tried updating the firmware to LX-Nano.328p.20150626.hex and now it's a solid green. I know nothing about Arduinos so sorry for being a noob! Any help would be greatly appreciated!

Thanks,
Justin

Zax

  • T2Laser
  • Global Moderator
  • Hero Member
  • *****
  • Posts: 7298
    • View Profile
    • T2Laser
Re: At a Loss
« Reply #1 on: March 04, 2021, 07:01:46 AM »
I can't help with Benbox but if you want to checkout T2Laser https://t2laser.org and contact me from my site or by email I will help you get the machine working.