Hello,
I hope someone can help me with the following.
Iam using the laser cut program for some time now and it works just fine om my Banggood set with a 3000mW laser.
But this week the board burned on the laser circuit, but the laser was still worked on an separate powerset.
Along with the set I also ordered a Eleksmaker v5,2 board which works after flashing with the 1.1e.
But the strange thing is that the Laser connector is giving a constant feed of 15V which also has blown (I think) my laser because its not workig anymore.
The program is working with the board and the stepper motors, but I don’t understand why the 15V is continuosly on the laser connector.
On the board the laser is with 3 pins + / gnd / S which I connected to the Laser board and connected the S on the ttl pin but it stays on the 15V output to the laser.
I hope anyone can help and thanks in advance.
Thanks in advance , Ton